HOW TO MAKE BELL

-

Take 7feet's grill pipe because one feet is going under the ground.And at edge of the bended pipe put hole and fix it with cycle chain.And another part of the chain take I faced angle and put hole at last of the angle and fix it at the at fixing chain we have to remove at the edge of one part bit and put in that hole and joint it with bit at same we have to do at next part.at the next edge of the grill pipe put two holes and put in that holes two 6mm rod's.digg the ground of one feet and put the grill pipe and pack it with concret.

Comments

Post a Comment

Popular posts from this blog

wooden box making

-
                                                  Stool making Aim:-Hand made stool Requirements:-Ply  wood, San Mick, nail's   process:-First l take a plywood and  cut it in to two pieces                         measure it by 3feet of width and height in to                                 same 3feet and cut it in to two pieces and at 1.6 on                     plywood cut a U shaped hole and fix both of them                       and at the top surface l take round faced                                       measured plywood and hammered it with                                     nail's and I designed it half heartcutted and apply it                   on the stool Conclusion:-I learned about how to make a innovative stool.
Read more

Practical carpentry materials information

-
Image
                               Carpent ry materials informaton                   1.   Karvat                     :-   Used to cut wood. 2.  Hand driller          :-   Man power machine                                              It uses to drill wood . 3.  State hammer       :-   Used to adjust wood peaces. 4.  Ambar                      :-    Uses to pull nails.   5.  Nishana                   :-    Uses to sharp wood to make slippery. 6.  Millet                        :-    Used in adjusting patra to wood .                                                              7.   Kikre                      :-    Used to remove useless wood.                                                                    8. Patashi                    :-   Used to remove useless wood. 9.  Round coil              :-   Used in carpentary work. 10. Squar coil               :-   Used in carpentary work . 11.  Claw hammer       :-   Used in hammering.   12.V
Read more

Practical INFORMATION ABOUT WELDING ROD

-
Image
                                              Weldingrod Date: 21/7/2017 Aim:Information about welding electrodes. Materials:- 1) kaolin                    2) starch                    3) chalk                    4) lime                    5)di-oxydigin                    6)coating and flux About:- Length:-350 mm              gauges:- 12 gauge               thikness:- 2.5 mm               types:- m.s rod, s.s rod, casting rod                AMP:- 80-110 am
Read more