Engineering and Workshop Technology

          DBRT STUDENT                                                2017-2018                                      Vigyan Ashram Section name        :-Engineering (workshop) Project name         :-Innovative tool for ploug Project by              :-Shaikh soyal    G uiders              :-  Laxman jadhav sir   Date of  starting project     :- 11-09-2017   Finishing date     :- 26-09-2017 Aim                      :-Innovative tool for ploug           -Note: Low cost and simple to use for digging in farms.  Introduction  :                       Usually Plough is used for digging but my institute                            not only teach about. How it works but it inspires me                        to learn science behind every tool. I used here I                                  learned how to make a modified and automated                                plough . I look out how it would be usefull for rural                          people in low cos

                                          measurement   Date:-25/7/2017 Aim:- To learn an handle different   measuring instruments. British type Matric type 1)Inch MM 2)Feet Cm 3)Mile M 4)Kosh Km 5)Fartan Acer 6)Dozen Gunta 7)Khandi(20 per nos) Kg’s 8)Man (40 kg) Gram’s 9)Ahuli (2.5 kg) Liter’s 10)Thola (10gm’s) Ml 11)Karat Quental (100kg’s) 12)1 hp Mili gram’s 13)Wind TAN (1000 kg’s)     Requirement's:-Tape,scale,vernier caliper,screw gauge,spirit level,plumb,rope     

                                              Weldingrod Date: 21/7/2017 Aim:Information about welding electrodes. Materials:- 1) kaolin                    2) starch                    3) chalk                    4) lime                    5)di-oxydigin                    6)coating and flux About:- Length:-350 mm              gauges:- 12 gauge               thikness:- 2.5 mm               types:- m.s rod, s.s rod, casting rod                AMP:- 80-110 am

Take   7feet's grill pipe because one feet is going under the ground.And at edge of the bended pipe put hole and fix it with cycle chain.And another part of the chain take I faced angle and put hole at last of the angle and fix it at the at fixing chain we have to remove at the edge of one part bit and put in that hole and joint it with bit at same we have to do at next part.at the next edge of the grill pipe put two holes and put in that holes two 6mm rod's.digg the ground of one feet and put the grill pipe and pack it with concret.

           Hi my name is soyal and I am In DBRT course i have learn hear many more things.I have learnt about how to operate machines.And how to bending  rod and how to do welding                            and how to draw solidwork's  in computer.There are four types of  section agriculture,electric,food lab, and workshop.I am in workshop that's .why i am taking about this things there is most beautiful nature here i am enjoying here.