-
                        HOW TO MAKE DOOR STOPPER                                              

          Take a 5 feet's of angle and cut it one side at half and bend it one side like two step's .One side bending on a angle and another side drilling hole at one side and opposite side put weight like rod piece and weld it .And fix at the door side and put bolt in that hole and tight it at the bottom in ground take a small piece of slap and put under the ground half in and half out because after we locking the the door locker comes back. To stop that we put that slap in the ground and fix with concret .THANK YOU TO READ IT

Comments

Post a Comment

Popular posts from this blog

wooden box making

-
                                                  Stool making Aim:-Hand made stool Requirements:-Ply  wood, San Mick, nail's   process:-First l take a plywood and  cut it in to two pieces                         measure it by 3feet of width and height in to                                 same 3feet and cut it in to two pieces and at 1.6 on                     plywood cut a U shaped hole and fix both of them                       and at the top surface l take round faced                                       measured plywood and hammered it with                                     nail's and I designed it half heartcutted and apply it                   on the stool Conclusion:-I learned about how to make a innovative stool.
Read more

Practical carpentry materials information

-
Image
                               Carpent ry materials informaton                   1.   Karvat                     :-   Used to cut wood. 2.  Hand driller          :-   Man power machine                                              It uses to drill wood . 3.  State hammer       :-   Used to adjust wood peaces. 4.  Ambar                      :-    Uses to pull nails.   5.  Nishana                   :-    Uses to sharp wood to make slippery. 6.  Millet                        :-    Used in adjusting patra to wood .                                                              7.   Kikre                      :-    Used to remove useless wood.                                                                    8. Patashi                    :-   Used to remove useless wood. 9.  Round coil              :-   Used in carpentary work. 10. Squar coil               :-   Used in carpentary work . 11.  Claw hammer       :-   Used in hammering.   12.V
Read more

Practical INFORMATION ABOUT WELDING ROD

-
Image
                                              Weldingrod Date: 21/7/2017 Aim:Information about welding electrodes. Materials:- 1) kaolin                    2) starch                    3) chalk                    4) lime                    5)di-oxydigin                    6)coating and flux About:- Length:-350 mm              gauges:- 12 gauge               thikness:- 2.5 mm               types:- m.s rod, s.s rod, casting rod                AMP:- 80-110 am
Read more